Re: {Collins} 516F-2 Bias setting



Leslie,

Last question.  Are you using the 6146, 6146A, or 6146B?

-----Original Message----- From: james.liles@xxxxxxxxxxx
Sent: Thursday, November 12, 2015 12:54 PM
To: Leslie Otto ; Listserve
Subject: Re: {Collins} 516F-2 Bias setting

Hi Otto,

Need to know what finals your using.

Regards Jim

-----Original Message----- From: Leslie Otto
Sent: Thursday, November 12, 2015 12:03 PM
To: Listserve
Subject: {Collins} 516F-2 Bias setting

I am trying to set the bias on a KWM-2A, but cannot seem to lower it below
60 ma.  I have Zeroed the meter with the rig off.  Then turned the rig on
waited a few minutes, set Mic Gain to Off, meter to Plate, and Emission to
Lock.  The pot is clockwise to the stop and the lowest reading on the meter
I can get is 60 ma.  Suggestions please.  Les  W9LSO
*** You are subscribed to Collins as james.liles@xxxxxxxxxxx. If you wish to
unsubscribe, or modify your preferences please visit
http://mailman.listserve.com/listmanager/listinfo/collins ***

*** You are subscribed to Collins as james.liles@xxxxxxxxxxx. If you wish to unsubscribe, or modify your preferences please visit http://mailman.listserve.com/listmanager/listinfo/collins ***



This archive was generated by a fusion of Pipermail (Mailman edition) and MHonArc.